The Module-X4 comes with a pigtail consisting of a network and an I/O cable.
The Module-X can be powered via PoE+ (IEEE 802.3at) using the network cable or by providing 24 - 48 Volt DC on the I/O cable.
Both cables have a length of 2 meters.
The I/O cable breaks out in 14 pins.
The wiring diagram can be found below and in the Quick start guide, that is enclosed in the box of the Module-X.
When using the relay functionality of the I/O cable, a Metal Oxide Varistaror (MOV) over the contacts of the screw terminals or connector where the I/O cable of the Module-X is connected, is required.
This will protect the camera from switching / induced surges and serves for noise suppression.
Version: I/O cable v5- AV0017-04 -TRVVSP *7P+F+AL +B OD:8. 7±0.2mm
Wiring diagram
P1 |
Color |
Description |
|
|---|---|---|---|
1 |
orange |
RS485- (B) |
OSDP |
2 |
white/red |
Wiegand D0 |
|
3 |
black |
Relay_B COM |
|
4 |
white/black |
Relay_A NO |
|
5 |
red |
Wiegand D1 |
|
6 |
black/orange |
RS485+ (A) |
OSDP |
7 |
brown |
GND |
|
8 |
black/brown |
Relay_B NO |
|
9 |
blue |
Relay_A COM |
|
10 |
black/blue |
CTL IN1 |
>2.2=high |
11 |
green |
GND |
|
12 |
black/green |
Wiegand GND in |
|
13 |
yellow |
EXT power in |
24VDC~48VDC |
14 |
black/yellow |
Wiegand +12V in |
